Configuring the server.conf Parameter in PPM

Note: For more information about the steps in this procedure, see the Installation and Administration Guide.

Add (if not present) and specify the parameter related to Service Manager integration to the PPM server.conf configuration file, as follows:

  1. Stop the PPM Server.

  2. Run the following script: 

    sh ./kConfig.sh

    Set the parameter and value as shown in the following table. (All parameter names begin with com.kintana.core.server. but that is not shown in the table.)

    Parameter

    Value

    MAC_LOG_SEVERITY

    Specify the level of logging to be used. When set to 0 (the default), only integration exceptions (errors) and a summary are logged. When set to 1, non-error events related to the processing of changes are also logged. See Error and Non-Error Logging.

  3. Restart the PPM Server.